Knots for bamboo fences
Basic Cross Tie
This lashing steadies the two poles by crossing in back and tying in front. Start with 18 inches (45.7 cm) of cordage. Referring to figures 1 through 3, proceed as follows:
1. Fold the cord in half and place diagonally across the intersection, both ends pulled toward the back.
2. In the back, twist the ends tightly together.
3. Bring the two ends back to the front and tie with a square knot.
Square Lashing
This is a sturdy lashing, good for structures. Starting with 36 inches (91.4 cm) of cord, refer to figures 1 through 3:
1. Attach one end with a clove hitch. Wrap the cord in a counterclockwise direction, bringing it under, over, under, and over the four poles. Pull tight at each wrap. Complete two or more full rotations.
2. Wrap between the poles, pulling tight and keeping each turn taut.
3. Tie the ends together in a square knot. Cut the ends.
Traditional Japanese Tie
This tie is suited for use as a decorative knot, not a strong lashing. It is often tied with two strands of twine (illustrations and directions are for a single strand). Using poles 1 inch (2.5 cm) in diameter, start with a length of 28 inches (70 cm) and refer to figures 1 through 5.
1. Place the twince diagonally across the intersection with both ends toward the back. Adjust the twince so cord A over the pole is 2 inches (5 cm) longer than cord B. Figure 1.
2. In back, cross and tightly twist. Bring the ends forward, the longer one (A) from the upper left corner and the shorter one (B) from the lower right corner. Figure 2, front and back.
3. Cross and tighten at the intersection. Bring cord A up. Keep taut by pinching the twine. Figure 3.
4. Bring A over and under B then up, making a clockwise loop. As it meets the intersection, place A under itself. Figure 5.
5. Twist B under A. Take B clockwise under, around, and through the loop. While pinching with your left hand, use your right hand to pull A to complete and tighten the knot. Figure 5.
6. Clip the ends to about 1 inch (2.5 cm).
Ibo knot